Server Alarms - Avaya Support

Server Alarms
UPS (Uninterruptible Power Supply)
This section contains tables which explain UPS Traps to the Server and UPS Alarms to the
Server.
When a UPS event occurs, an alarm will be raised and the server state of health will be
degraded. The server will not shut down as long as battery power is available. It is the goal of
Communication Manager to provide call processing service for as long as possible.
Given the highly reliable file systems and recovery mechanisms in place, it is expected that no
damage will be done to the server. The server is expected to recover normally even if the UPS
runs of out battery backup and the server catastrophically loses power.
After power has been restored and the system has been up for approximately 1 hour 15
minutes, the alarm will be resolved automatically.
UPS Traps to the Server
Table 34: Enterprise-Specific UPS Traps to Server contains the various UPS-generated SNMP
traps to the server.
Table 34: Enterprise-Specific UPS Traps to Server 1 of 3
SNMP Trap from UPS Event
ID
Definition of Trap
Trap (1) #1–8 Alarm string = #1, ACT, UPS, A, Event ID #, MAJ,
Warning, system power failure: Possible UPS
exhaustion in 1 - 8 minutes.
The UPS battery’s power is in a critically low
condition, with an estimated 8 minutes or less of
remaining holdover.
● A warning is sent to every logged-in user of
the server.
For troubleshooting procedures, see Events #1–8
Trap (3)
upsAlarmShutdownPending
Trap (3)
upsAlarmShutdownPending
Trap (3) 1
upsAlarmShutdownImminent
#11 Alarm string = #1, ACT, UPS, A, 11, WRN,
Miscellaneous trap, e.g., bad battery.
For troubleshooting procedures, see Event #11
#12 Alarm string = #1, ACT, UPS, A, 12, WRN,
Miscellaneous trap, e.g., bad battery.
For troubleshooting procedures, see Event #12
#13 Alarm string = #1,ACT, UPS, A, 13, MAJ,
Miscellaneous trap, e.g., bad battery.
For troubleshooting procedures, see Event #13
114 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 3