Server Alarms - Avaya Support

Auxiliary Trunk Diagnostic Test (#114)
Auxiliary Trunk Diagnostic Test (#114)
The system sends a message to the on-board microprocessor to operate a relay in the port
circuit. If ground is detected, the test passes. This test runs on the AUX-TRK (Auxiliary Trunk)
maintenance object.
Table 419: Auxiliary Trunk Diagnostic Test (#114)
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service
state of the port. If the port is in use, wait until it is idle.
3. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service
state of the port. If the port is in use, wait until it is idle.
3. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The test failed to detect ground.
1. Rerun the test.
2. If the test fails again, replace the circuit pack.
PASS This test passed. Ground was detected.
Communication Manager Release 5.0 Issue 4 January 2008 1561