Server Alarms - Avaya Support

CO Port Diagnostic Test (#3)
CO Port Diagnostic Test (#3)
For ground start trunks, circuit pack or media module port relays are operated and checked to
see if the port can detect and apply ground on the Tip lead. This test also verifies that there is no
external ground on the Ring lead. In the absence of other failures, the circuit pack or media
module should be replaced only if this test fails with the CO line disconnected.
This test also checks the on-board programmable transmission circuits that allow the circuit
pack or media module to support transmission characteristics of several different countries.
This test runs on CO-TRK (Analog CO Trunk) and DIOD-TRK (DIOD Trunk).
Table 378: CO Port Diagnostic Test (#3) 1 of 2
Error
Code
1000
1004
Test
Result
Description / Recommendation
ABORT Could not allocate system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ABORT System resources required to run this test are not available.
The port may be busy with a valid call.
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service state of the port. If
the service state indicates that the port is in use, wait until the port is
idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Test is not valid for the present configuration. This error can be ignored.
1018 ABORT Test has been disabled by administration. Determine why this test was
disabled before enabling it.
1. To enable the test, enter change trunk-group and
enter y in the Maintenance Tests field on the Trunk Group form.
2. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1433