Server Alarms - Avaya Support

Table 415: Modem Pool Conference Test (#97) 3 of 4
Error
Code
Test
Result
Description / Recommendation
Modem Pool Conference Test (#97)
4000 ABORT System resources needed to complete the test could not be allocated.
This usually means the conversion resource or other hardware needed
for the test was in use.
1. Wait 1 minute and run the test again.
2. If the same error occurs, enter status port to determine whether
the Modem Pool conversion resource is in use.
3. If the conversion resource is in use, and it is absolutely necessary to
test it, the call must be dropped by entering busyout port
location against the conversion resource. Run the test again.
4. If the same error occurs while the conversion resource is idle,
busyout both Modem Pool conversion resources on the TN758
Pooled Modem circuit pack containing the conversion resource
under test. Run the test again.
5. If the test continues to abort, replace the Pooled Modem circuit pack
and retest.
65515 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
2. Enter test port location long for the port on which the test
aborted. If any test aborted or failed, follow the recommended repair
procedures for the appropriate port type (for example, ANL-LINE
(8-Port Analog Line), DIG-LINE (Digital Line)).
FAIL This error is internal to the Pooled Modem circuit pack and does not
involve external equipment or interfaces.
1. Busyout both of the TN758 Pooled Modem conversion resources on
the circuit pack containing the failing conversion resource.
2. If the test continues to fail, replace the Pooled Modem circuit pack
and retest.
3 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1551