Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 474: Signaling Link State Audit Test (#255) 1 of 2
Error
Code
None
or 0
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry the command up to 5 times at 1-minute intervals.
1018 ABORT Test is disabled by administration.
1. To enable the test, enter y in the Maintenance Tests field on the
change trunk-group screen.
1114 ABORT The signaling link is in a transitional state
1. Retry the command up to 5 times at 1-minute intervals.
1700 ABORT Rollabout video abort for PE-BCHL. The PRI terminal adapter
associated with this PRI endpoint extension is detached from the circuit
pack. This is a normal abort when the rollabout video feature is enabled.
1. Either reconnect the disconnected PRI terminal adapter or disable
the rollabout video feature on this circuit pack. To do the latter, enter
change ds1 location and set the Alarm when PRI Endpoint
Detached? field to y.
4 FAIL There is a problem with the signaling channel.
ATM-BCH:
1. Look for errors or alarms against ATM-SGRP and ATM-DCH, and
refer to ATM-SGRP (ATM Signaling Group) and ATM-DCH (ATM
D-Channel Port) for the appropriate repair procedures.
ISDN-TRK:
1. If the Packet Control circuit pack is used, consult the procedures for
ISDN-SGR (ISDN-PRI Signaling Group). Further information may
also be obtained by consulting the procedures for the ISDN-PLK
(ISDN-PRI Signaling Link Port).
2. If the Packet Interface is used, consult the procedures for PKT-INT
(Packet Interface)
PE-BCH: There is a problem with the Signaling Channel and/or with the
System Link.
1. Consult procedures for ISDN-SGR (ISDN-PRI Signaling Group) and
SYS-LINK (System Links). See also ISDN-PLK (ISDN-PRI Signaling
Link Port) for useful information.
1684 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2