Server Alarms - Avaya Support

Table 605: ATM Crosstalk Test (#1298) 2 of 2
Error
Code
ATM Crosstalk Test (#1298)
1394 ABORT The ATM-EI board is out of service and the test cannot be run.
1. Run Test #241. If it does not pass, see repair procedures for
Expansion Interface 2-Way Transmission Test (#241).
1395 ABORT This test cannot be run on an ATM-EI circuit pack if it is part of the
B-side PNC and duplicated PNC is not enabled.
1. If this test needs to run on this ATM-EI circuit pack, enable PNC
duplication with change system-parameters duplication.
2. Prevent the system from doing a PNC interchange with
set PNC lock.
3. Repeat this test.
1407 ABORT This test cannot be run on an ATM-EI board that is on the active PNC
because it cannot be busied out. This error code indicates that PNC
duplication is enabled.
1. Attempt to perform a PNC interchange with
reset pnc interchange.
2. If the PNC interchange is successful, busyout the original
ATM-Expansion Interface circuit pack with busyout board
location (address of the original ATM-EI board).
3. Retry the command.
1962
2000
2100
2302
2500
Test
Result
Description / Recommendation
ABORT Every TALKER DSP is busy (an unlikely event).
Response to the test was not received within the allowed time.
Could not allocate the necessary system resources to run this test.
Inconsistent uplink message from the ATM board.
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2752 ABORT The circuit pack in this location is not a TN2305 or TN2306.
1–8 FAIL The board is writing to unauthorized TDM time slots. The error code
indicates the number of faulted TALKER DSPs.
1. Retry the command up to 3 times.
2. If the failure persists, replace the circuit pack.
1–8 PASS The board is talking to authorized time slots on the TDM Bus. The error
code indicates the number of TALKER DSPs that were tested.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1983