Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on ATM-EI and ATM-TRK circuit packs. It is only executed as part of the
reset board location command. The board must first be busied out in order to run this
test.
This test runs on the ATM-EI (Expansion Interface Circuit Pack) and ATM-TRK (Circuit
Emulation Service Circuit Pack) maintenance objects.
ATM-EI: If the ATM-EI board is a standby in a PN, the reset is done through the SAKI reset
interface. If the ATM-EI is an Expansion Archangel (active ATM-EI board in the PN) and if the
EAL is present, a special message is sent to the board over the EAL.
ATM-TRK: This test checks the sanity of the Angel processor using the Sanity and Control
Interface (SAKI) test (#53). It resets the circuit pack if the SAKI test fails and runs the test
again.The ATM Board Reset test passes if SAKI can successfully reset the board.
Before running the SAKI test on an ATM-TRK circuit pack, you must:
● Move synchronization off the ATM-TRK circuit pack
● Busyout the ATM-TRK circuit pack
The test aborts if the ATM-TRK circuit pack is supplying synchronization.
Table 590: ATM Board Reset (#1256) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Could not allocate the required system resources
1. Retry the command up to 5 times at 1-minute intervals.
2. If the test continues to abort escalate the problem.
1005 ABORT Wrong circuit pack configuration to run this test. The ATM CES Trunk
Interface circuit pack provides timing for the system and cannot be reset
without major system disruptions.
1. Set synchronization to another ATM CES trunk circuit pack or to the
Tone-Clock circuit pack and test again.
1015 ABORT The ATM-TRK circuit pack has not been busied out.
1. Busyout out the circuit pack with busyout board location
2. Repeat the test with test board location long
1386 ABORT No Active EAL to the board. This error applies only if the board under test is
in a PN. Check the error logs for SYS-LINK (System Links) errors against
the PN where the ATM-EI resides, and take appropriate diagnostic action for
the SYS-LINK.
1954 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2