Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
If the test has failed within the last 5 minutes, there is a 15 second delay before the result is
returned. This prevents a repeated sequence of this test from always reporting the same result.
If the test passes and a FAIL has not occurred within the last five minutes, a PASS is returned
immediately.
This test is run on PKT-BUS (Packet Bus).
Table 496: Packet Circuit Pack Audit Test (#573)
Error
Code
Test
Result
Description / Recommendation
2500 ABORT Internal error.
1. Retry the command at 1-minute intervals up to 5 times.
1 FAIL One Packet circuit pack has reported packet bus-related inline errors within
the last minute.
2 FAIL More than one Packet circuit pack has reported packet bus-related inline
errors within the last minute.
PASS No Packet circuit packs have reported packet bus-related inline errors
within the last minute. This indicates that the packet bus is healthy, or that a
packet bus fault is transient or is being caused by a faulty Packet circuit
pack. If this test passes, but there are other signs of a packet bus failure
such as logged errors or alarms or other test failures, see Isolating and
repairing packet-bus faults in Maintenance Procedures (03-300432).
Board Type Check Test (#574)
This test verifies that a Tone-Clock circuit pack administered with a Stratum-3 clock source has
board code TN780.
This test runs on the following maintenance objects:
● TDM-CLK (TDM Bus Clock)
● TONE-BD (Tone-Clock Circuit Pack)
● TONE-PT (Tone Generator)
1726 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers