Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 575: MMI Update Synchronization Status Test (#1123) 2 of 2
Error
Code
Test
Result
Description / Recommendation
2000 ABORT A response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times. If this result
occurs repeatedly and the MMI circuit pack is idle, reset the circuit
pack.
2. Rerun the test. If the same result occurs again, replace the MMI
circuit pack.
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The MMI circuit pack is out of MMI synchronization.
1. Run the long option of the test board command.
2. Wait 5 minutes, then reset the circuit pack.
3. Rerun the test. If the same result occurs again, replace the circuit
pack.
1100 PASS The MMI circuit pack is providing the synchronization correctly. This MMI
circuit pack is designated as the Master Sync source.
1101 PASS The MMI circuit pack is listening to the synchronization signal correctly.
Digital Terminal Remote Looparound Test (#1201)
This test checks the connection between the server and the digital terminal. It verifies the ability
of the terminal and the associated port to send and receive data. This test is based on
procedure 622 to isolate digital terminal problems.
1922 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 2