Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
RC NPE Port Audit Test (#1315)
This tests executes the NPE crosstalk test on a Radio controller (RC) NPE port. If the test is
unsuccessful, the port number (1-24) of the RC NPE port which failed is returned.
Not all ports are tested, as this would take an excessive amount of time. It is most likely that if
one port fails, then all of the ports are bad. To test all 24 RC NPE ports, use the repeat 24
option for the test board command. This test is run on RC-BD (Radio Controller Board).
Table 606: RC NPE Port Audit Test (#1315) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1-24 ABORT The Error Code identifies the NPE for which the test aborted. The NPE
is probably being allocated for a call.
1. Enter status radio-controller loc to verify there are no
calls on the RC circuit pack.
2. If not, retry the command at one-minute intervals up to 5 times.
3. If the test continues to abort, escalate the problem.
1-24 FAIL The Error Code identifies the NPE for which the RC NPE Port
Crosstalk test failed.
1. Enter test board loc long repeat 24
2. If any of the tests fail, replace the RC circuit pack.
1984 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2