Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
would be out of service due to the alarm. (There are five Tone Detectors on each of the
two DSPs.) Other than the unlikely potential of running out of Tone Detector resources in
the switch, there is no other effect when the board is reset.
2. Test the board with test board location long.
3. If the test still fails, replace the board.
b. Error 257: The CLSFY-PT lost its translation. Testing the CLSFY-PT is sufficient to reload
its translation. If testing the call classifier port does not clear the error, then the call classifier
circuit pack containing the defective call classifier port should be replaced.
c. Error 513: This error indicates the call classifier port is having problems detecting call
classification tones or detecting and generating R2-MFC tones This is usually accompanied
by failures of some incoming or outgoing calls. If this Error Type is persistently logged, then
replace the call classifier circuit pack containing the defective CLSFY-PT.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of Investigation Short Test
Sequence
1. D = Destructive; ND = Nondestructive
Long Test
Sequence
650 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
D/ND 1
Tone Detection Verification Test (#42) X X ND
Tone Detector Audit/Update Test (#43) X X ND