Server Alarms - Avaya Support

Signaling Link State Test (#1251)
Signaling Link State Test (#1251)
This test checks the current state of the signaling link. The test looks at the board-level
translations, checks that the board is physically inserted, then gets the state of the D-channel
and service state of the port.
The test passes if the signaling link (D-channel) is connected and operating normally. The test
fails if the board is not installed, the signaling link is disconnected, or if the port is out of service.
The test aborts otherwise.
This test runs on TBRI-TRK (ISDN Trunk-Side BRI Channel).
Table 589: Signaling Link State Test (#1251)
Error
Code
Test
Result
ATM Board Reset (#1256)
This test is destructive.
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
1018 ABORT The test is disabled.
1. Enable the test by entering enable test 1251.
1114 ABORT The signaling link is in a transitional state.
1. Retry the command at 1-minute intervals up to 5 times.
8 FAIL The signaling link is down.
1. Consult the procedures for TBRI-TRK (ISDN Trunk-Side BRI
Channel).
9 FAIL The port is out of service.
1. Consult the procedures for TBRI-PT (ISDN Trunk-Side BRI Port).
PASS The signaling link is connected and operating normally.
Communication Manager Release 5.0 Issue 4 January 2008 1953