Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 196: DTMR-PT Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
1 (d) 17664 Tone Detector
Audit/ Update test
(#43)
MAJ
MIN
(b)
ON test port location r 2
18 0 busyout port
location
WRN ON release port location
130 (e) None WRN ON test port location r 2
257 (c) 17666 Tone Detector
Audit/ Update test
(#43)
513 (d) Any Tone Detection
Verification test
(#42)
MAJ
MIN
(b)
MAJ
MIN
(b)
On/Off
Board
Recommended Action
ON test port location r 3
ON test port location r 3
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its recommended procedures.
b. There are two possible alarm levels for this error. A Major alarm is raised if the total number
of DTMR ports currently in service is less than or equal to 1/2 of the administered threshold
number. Otherwise, a Minor alarm is raised. In either case, run the short test sequence
against the DTMR port and follow the repair procedures for the individual tests.
The threshold number of DTMR ports for service is administered using
change system-parameters maintenance.
c. Error Type 257: The DTMR port lost its translation. Testing the DTMR port is sufficient to
reload its translation. If testing the DTMR port does not clear the error, then the IPSI or Tone
Detector circuit pack containing the defective DTMR port should be replaced.
d. Error Type 513: The DTMR port is having problems detecting touch-tone digits. If this error
is being constantly logged, the IPSI or Tone Detector circuit pack containing the defective
DTMR port should be replaced.
e. Error Type 130: The circuit pack has been removed or has been insane for at least 11
minutes. To clear the error, reinsert or replace the circuit pack.
772 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers