Server Alarms - Avaya Support

Table 544: Reset Board Test (#787) 2 of 2
Error
Code
Test
Result
Far-End DS1 Converter Circuit Pack
Loopback Test (#788)
Far-End DS1 Converter Circuit Pack Loopback Test (#788)
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The timer could not be set before sending the downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Enter add fiber-link to administer the DS1 converter fiber link.
2321 ABORT DS1 converter circuit pack is not busied out.
1. Enter busyout board to busyout the DS1 converter circuit pack.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
PASS The reset sequence was executed successfully. However, this test result
does not indicate whether the firmware diagnostic tests passed.
1. Enter display errors and check the error log for Error Type 1 for
this circuit pack’s location. This indicates a failed diagnostic firmware
test.
2. Enter display alarms to check the alarm log for any ON-BOARD
MAJOR alarms.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
This test is destructive.
This test is executed by the TN574 DS1 Converter circuit pack only. See DS1 Facilities
Connectivity Test (#790) for testing the TN1654 DS1 Converter.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1851