Server Alarms - Avaya Support

Table 130: ATM-EI Error Log Entries 3 of 3
Error
Type
3585 (u) ATM Framer
Looparound (#1260)
3586 (u) ATM Framer
Looparound (#1260)
3841 (v)
3842(w)
3843 (x)
Aux
Data
3999 (y) Any
Any (z) 32767
Associated Test Alarm
Level
ATM-EI (Expansion Interface Circuit Pack)
On/Off
Board
Recommended Action
MAJ ON test board location l
MAJ ON test board location l
3 of 3
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 2: The on-board DUART chip failed. This results in communication failure
between the PN’s Maintenance board and the ATM-EI board. The Maintenance board
should have a red LED lit because the link to the ATM-EI is down in this PN.
1. Reset the board with reset board location.
2. If the board does not recover, replace the board.
c. Error Type 18: The ATM-EI circuit pack has been busied out.
1. Release the circuit pack (release board location).
d. Error Type 23: An ATM-EI circuit pack has been administered with the add atm pnc n
command, but the circuit pack has not been physically inserted into the system.
1. Insert an ATM-EI circuit pack at this location.
e. Error Type 125: A wrong circuit pack is located in the slot where the ATM-EI circuit pack is
logically administered.
1. Either remove the wrong circuit pack and insert the ATM-EI circuit pack or remove the
ATM-EI administration. See Basic ATM PNC Administration.
2. Remove the ATM-INTF administration and re-administer the slot (change circuit-pack) to
match the circuit-pack that is physically present in this slot.
Communication Manager Release 5.0 Issue 4 January 2008 509