Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
The test aborts if the system resources such as TDM time slots and Tone Generator are not
available.
This test applies to TN2305 and TN2306 ATM-EIs, both active and standby. It runs on ATM-EI
(Expansion Interface Circuit Pack) and ATM-TRK (Circuit Emulation Service Circuit Pack).
Table 604: ATM Board DSP Test (#1293) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic when
the Call Processing Occupancy is greater than 50% or when the System
Management and the Call Processing Occupancies together exceed
65%.
1. Enter status health to view the occupancy measurements.
2. Enter display errors and resolve any TDM-BUS (TDM Bus)
errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1962 ABORT Every DSP is busy. This is a very unlikely event.
1. Retry the command at 1-minute intervals up to 3 times.
2000 ABORT Response to the test was not received within the allowed time.
1. If the board is in standby, reset the board and run the test again.
2. Check the Error Log for Error Type 1281 (bad DSP). If Error Type
1281 is not logged against this board, run the DSP test again.
3. If the error persists, escalate.
1980 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2