Server Alarms - Avaya Support

Expansion Interface Lock Query Test (#304)
Expansion Interface Lock Query Test (#304)
The Expansion Interface Lock Query Test queries the ATM EI circuit pack for its status
concerning a lock to the backplane system clock. The test passes if the response is "in lock".
The test fails if the response is "out of lock". This test runs on ATM-EI (Expansion Interface
Circuit Pack).
Table 483: Expansion Interface Lock Query Test (#304) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2000 ABORT Response from the test was not received within the time allowed.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL A PN’s unduplicated ATM-EI circuit pack responded incorrectly, or a PN’s
active ATM-EI circuit pack could not communicate with the PN’s circuit
packs.
1. If the PN’s active ATM-EI circuit pack is failing and duplicated PNC is
enabled:
a. Enter reset PNC interchange to switch to the standby PNC.
b. Repeat the short test sequence.
c. If test continues to fail, enter reset board location to reset
the ATM-EI circuit pack.
2. If the PN’s unduplicated ATM-EI circuit pack is failing:
a. Enter display errors and display alarms, and follow the
associated repair procedures for TDM-CLK, TONE-BD, or SYNC
alarms/errors.
b. Repeat the short test sequence.
c. If test continues to fail, replace the circuit pack or transceiver.
PASS Communication to the ATM-EI circuit pack is functioning correctly.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1701