Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 601: TDM Looparound Test (#1285)
Error
Code
Test
Result
Description / Recommendation
1000 ABORT The port is in use.
1. Retry the command when the port is idle. The port may be forced to
the idle state by entering busyout port location.
Note: The busyout port command is destructive, causing every call and
link associated with the port to be torn down.
1002 ABORT No TDM bus timeslots available for the test.
1. Retry the command at 1-minute intervals up to 5 times.
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Did not receive test response within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times. If this problem
persists, reset the circuit pack and rerun the test.
2. If the problem persists, replace the circuit pack.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
1974 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2