Server Alarms - Avaya Support

Table 275: MET-LINE Error Log Entries 2 of 2
Error
Type
Aux
Data
1 (b) 40987
MET-LINE (MET Line)
18 (c) 0 busyout port
location
WRN OFF release port location
130 (d) WRN ON test port location
257 (e) 40988 MIN
WRN1 OFF
513 (f) 40965 Analog Line
Audits (#61)
WRN OFF test port location r 4
769 Port Diagnostic
Test (#35)
1025 Hybrid and Conf.
Circuits (#57)
1537 (g) 40968 MIN OFF
1
WRN
1793 NPE Crosstalk
Test (#6)
2049 (h) 32770
2049 (h) 40967
3840 (i) 40989
Associated Test Alarm
Level
On/Off
Board
Recommended Action
MIN ON test port location l r 3
1
WRN
MIN ON test port location l r 3
WRN1 MIN ON test port location l r 3
1
WRN
1. Major or Minor alarms MO can be downgraded to Warning based on the values in set options.
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description and follow its procedures.
2 of 2
b. Error Type 1: the data link between the port and the terminal is not operational (that is, the
port circuitry has detected an off-board problem). Verify that the MET set is connected and
that the EPF (Electronic Power Feed) test passes. If data transmission problems are
experienced, check for defective wiring or a defective voice terminal, or move terminal
electrically closer to the switch (that is, reduce the length of the wiring between the terminal
and the switch). If the problem persists, replace the circuit pack. Once the problem is
resolved, the system retires the alarm after a predetermined time delay.
c. Error Type 18: is logged when maintenance personnel busyout the port. The port is
released from busyout using release port location.
Communication Manager Release 5.0 Issue 4 January 2008 993