Server Alarms - Avaya Support

Table 559: Signaling Port LAN Loopback Test (#939) 2 of 2
Error
Code
Test
Result
Failure Audit Test (#949)
Description / Recommendation
Failure Audit Test (#949)
1139 ABORT This port network’s packet bus is out of service.
1. Follow repair procedures for the packet bus.
2. Enter test port location long, and check results of Test
(#939).
1141 ABORT The Packet Interface circuit pack is out of service.
1. Follow the repair procedures for PKT-INT (Packet Interface).
2. Enter test port location long, and check results of this test
(#939).
1144 ABRT The PPN’s packet bus is out of service.
1. Follow repair procedures for the packet bus.
2. Enter test port location long command and check results of
this test (#939).
1412 ABORT This test does not run on a media module or media gateway. Ignore.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The Loopback Test failed.
1. If the test fails repeatedly, attempt to reset the circuit pack when the
other ports on the board are idle.
2. Repeat the test. If it continues to fail, replace the circuit pack.
PASS Connectivity of the D-channel over the packet bus is operational.
This test queries the DS1 converter circuit pack for any existing circuit pack or facility failures
and any unacknowledged cleared failure messages.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1891