Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
BRI Port Local LAN Looparound Test (#618)
This test is destructive.
This test checks the connectivity of a BRI port across the LAN Bus and executes only if the port
is out-of-service. The test aborts if calls associated with the port are in-progress. Failures of this
test indicate either on-board faults associated with the port hardware on the circuit pack or
problems with the LAN Bus.
This test runs on the following maintenance objects:
● ASAI-PT (ASAI Port)
● BRI-PORT (ISDN-BRI Port)
● TBRI-PT (ISDN Trunk-Side BRI Port)
Table 508: BRI Port Local LAN Looparound Test (#618) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1015 ABORT The port is not out-of-service.
1. Enter status bri-port location to determine what stations or
adjuncts are on this port.
2. Enter status station extension to determine whether the
station or adjunct is in use.
3. If the port is in use, wait until it is idle, then busyout the port with
busyout port location to place it in the out-of-service state.
Repeat this test.
WARNING: Since
! WARNING:
the “busyout” command is destructive, execution of
this command prior to the port being idle causes every call
associated with BRI endpoints and every transaction
associated with ASAI or Avaya adjuncts on the port to be
torn down. Note that 3rd-party calls established by an
ASAI or Avaya adjunct remain connected even though the
port is taken out-of-service.
1139 ABORT The packet bus in the port network is out-of-service.
1. Follow the repair procedures for the PKT-BUS (Packet Bus).
2. Enter test port long location and view the results of the BRI
Port Local LAN Looparound Test #618 to verify the repair.
1750 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2