Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 506: TSC Heartbeat Inquiry Test (#604)
Error
Code
Test
Result
Description / Recommendation
1 FAIL The Administered TSC is not active (far end).
1. Enter test tsc-administered.
2. Verify that the Administered TSC node on the other side of the
network is active.
3. Disable and enable the Administered TSC.
4. Retry test tsc-administered.
2 FAIL Facility IE (Information Element) reject.
1. Check every other node in the network, and make sure Administered
TSC is active.
PASS The Administered TSC responded to a heartbeat.
BRI NPE Crosstalk Test (#617)
This test is destructive.
One or more Network Processor Elements (NPEs) reside on each circuit pack with a TDM-bus
interface. The NPE controls port connectivity and gain, and provides conferencing functions on
a per-port basis. The BRI NPE Crosstalk test verifies that the port’s NPE channel talks on the
selected time slot and never crosses over to time slots reserved for other connections. If the
NPE is not working correctly, one-way and noisy connections may be observed. This test is part
of a port’s long test sequence and executes in approximately 20 to 30 seconds. Crosstalk
testing is performed on both B-Channels (B1 and B2) associated with a BRI port. If this test fails
on either channel, any endpoint connected to the port is taken out-of-service. This test aborts if
the port and its associated channels are not in the idle state.
This test runs on BRI-PORT (ISDN-BRI Port) and TBRI-PT (ISDN Trunk-Side BRI Port).
1748 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
4 of 4