Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Note: An
Note:
MIM is a level 3 message that conveys management and maintenance
information between a communications system and a BRI terminal.
For endpoints of this type, the signaling link is “bound” when the link is connected at Layer 2
and the link has been associated with an endpoint, [that is, the endpoint has completed
SPID initialization (L3 established)].
● ASAI adjuncts and BRI endpoints not administered for MIM initialization (point-to-point):
For endpoints of this type, the signaling link is “bound” when the link is connected at Layer 2
(L2 established).
For every endpoint type, a signaling link becomes “unbound” when it is disconnected at Layer 2.
For BRI endpoints supporting MIM initialization, a signaling link may also become “unbound” if a
subsequent attempt to perform SPID initialization on a “bound” link fails (that is, wrong SPID is
entered into the endpoint by the user).
This test runs on ASAI-EPT (ASAI Endpoint) and BRI-SET, Various Adjuncts.
Table 516: Signaling Link Status Test (#626) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1139 ABORT The PN’s packet bus is out-of-service.
1. Follow the repair procedures for the PKT-BUS (Packet Bus).
2. After completing step 1, enter test port long location, and
review the results of the BRI Port Local LAN Looparound Test (#618)
to verify the repair.
1144 ABRT The PPN’s packet bus is out-of-service.
1. Follow the repair procedures for the PPN’s packet bus.
2. After completing step 1, execute test port long PCSSpp, and
review the results of the BRI Port Local LAN Loop Around test (#618)
to verify the repair.
1764 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2