Server Alarms - Avaya Support

Table 400: SAKI Sanity Test (#53) 2 of 2
Error
Code
Test
Result
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack or media module with
busyout board location
2. Enter reset board location
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
SAKI Sanity Test (#53)
2803 ABORT This error applies to IP Media Processors only. The IP interface must be
disabled before running this command.
1. Use the change ip-interfaces screen to disable the media
processor’s IP interface.
2. Enter the command again.
3. If the test passes, re-enable the media processor’s IP interface
using the change ip-interfaces screen.
2966 ABORT This error applies to TN2501 VAL boards only. An announcement
autosave is in progress on the board and the reset cannot be performed
at this time.
1. Wait a few minutes, then retry the command.
1 FAIL The circuit pack or media module failed to reset.
1. Enter the command again.
2. If the problem persists, replace the circuit pack or media module.
2 FAIL The circuit pack or media module failed to restart.
1. Enter reset board location again.
2. If the problem persists, escalate this problem.
ANY NO
BOARD
Description / Recommendation
PASS The circuit pack or media module initialized correctly.
See NO BOARD for the repair procedures.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1519