Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 342: SYNC Error Log Entries 2 of 2
Error Type Aux
Data
Associated Test Alarm
Level
1 (b)(i) WRN
MIN (g)
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 1: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
This error indicates a problem with the primary DS1 reference. It is cleared when the
primary reference is restored. To find the problem’s source:
1. Enter list configuration board location to check if the primary DS1 Interface
circuit pack is inserted in the carrier.
2. Verify that the administered primary reference matches the DS1 reference from the
network synchronization plan.
3. Enter test board location long to test the primary DS1 Interface circuit pack.
Check the Error Log for DS1-BD or UDS1-BD errors and see DS1-BD (DS1 Interface
Circuit Pack) or UDS1-BD (UDS1 Interface Circuit Pack) to resolve errors associated
with the primary DS1 (DS1 or UDS1) interface circuit pack.
If the only errors against DS1-BD or UDS1-BD are slip errors, follow the procedures
described in the previous troubleshooting section. If no errors are listed in the Error Log
for the primary DS1 Interface circuit pack, continue with the following steps.
1276 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
OFF
18 (c) 0 disable sync WRN OFF enable sync
257 (d)(i) WRN
MIN (i)(g)
513 (e)(i) WRN
MAJ (i)(g)
OFF
OFF
769 (f) MAJ OFF
1793 (g) 1 0–50 MAJ OFF
2049 (h) 0 WRN OFF
1. It can take up to 1 hour for these alarms to clear.
On/Off
Board
Recommended Action
2 of 2