09.12.2012 Views

Server Alarms - Avaya Support

Server Alarms - Avaya Support

Server Alarms - Avaya Support

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Communication Manager Maintenance Object Repair Procedures<br />

When the DS1 board detects a Red Alarm, it transmits a Yellow Alarm to the remote DS1<br />

endpoint and sends a Red Alarm message to the system. After the Red Alarm is confirmed, the<br />

system places every trunk or port of the DS1 board into the out-of-service state. The inquiry test<br />

runs every 10 minutes until the Red Alarm is cleared.<br />

When the Red Alarm is cleared, the DS1 board stops transmitting the Yellow alarm to the<br />

remote DS1 endpoint. The system restores all trunks or ports of the DS1 board to the service<br />

state they were in before the Red Alarm occurred.<br />

This test is run on the following maintenance objects:<br />

● DS1-BD (DS1 Interface Circuit Pack)<br />

● MAPD-BD (MAPD Interface Circuit Pack)<br />

● MG-DS1 (DS1 Interface Media Module)<br />

● UDS1-BD (UDS1 Interface Circuit Pack)<br />

Loss of Multiframe Alarm<br />

If the DS1 circuit pack or media module is administered using DMI-BOS signaling, it raises a<br />

LMA (Loss of Multiframe Alarm) when it cannot interpret the incoming signaling bits to<br />

synchronize to the multiframe pattern received in the 24 th channel. Once the DS1 board detects<br />

an LMA, the circuit pack transmits a RMA (Remote Multiframe Alarm) to the remote DS1<br />

endpoint.<br />

Table 434: Red Alarm Inquiry Test (#140) 1 of 2<br />

Error<br />

Code<br />

Test<br />

Result<br />

Description / Recommendation<br />

ABORT Internal system error<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

2000 ABORT Response to the test was not received within the allowed time. This may<br />

be due to hyperactivity.<br />

1. Enter display errors on the SAT.<br />

2. Check for Error Type 1538 for this DS1 board. If Error Type 1538<br />

appears in the error log for this board, see Hyperactive DS1/UDS1<br />

Interface Circuit Pack/Media Module for the repair procedures.<br />

Otherwise, retry the test at 1-minute intervals up to 5 times.<br />

2100 ABORT Could not allocate resources for this test.<br />

1. Retry the command at 1-minute intervals up to 5 times.<br />

1604 Maintenance <strong>Alarms</strong> for <strong>Avaya</strong> Communication Manager, Media Gateways and <strong>Server</strong>s<br />

1 of 2

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!