Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
For IPMEDPRO: Use the change ip-interface screen to disable the Media Processor’s IP
interface before performing this procedure.
For the Tone-Clock circuit packs, DS1 Interface circuit packs, and DS1 Interface Media
Modules, this test is executed as part of the long test sequence.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MEDPRO (Media Processor MAPD Circuit Pack)
● MG-ANA (Analog Media Module)
● MG-DS1 (DS1 Interface Media Module)
● MMI-BD (Multimedia Interface Circuit Pack)
● RC-BD (Radio Controller Board)
● TDM-CLK (TDM Bus Clock)
● TONE-BD (Tone-Clock Circuit Pack)
● TONE-PT (Tone Generator)
● UDS1-BD (UDS1 Interface Circuit Pack)
● XXX-BD (Common Port Circuit Pack/Media Module)
Table 400: SAKI Sanity Test (#53) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT This error applies only to DS1 interface circuit packs and DS1 media
modules. It means the DS1 interface circuit pack or media module is
providing timing for the system and, therefore, it cannot be reset without
causing major system disruptions. If this is not a media gateway
system, go to Step 1. If this is a media gateway system, go to Step 2.
1. If the circuit pack needs to be reset, set synchronization to another
DS1 interface circuit pack or the Tone-Clock circuit pack and try the
command again. See SYNC (Port Network Synchronization).
2. If the DS1 Media Module needs to be reset, set the synchronization
timing source to another DS1 interface Media Module located in the
same media gateway and retest. See Setting G700 synchronization
in Maintenance Procedures (03-300432).
1518 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2