Server Alarms - Avaya Support

This test is run on RC-BD (Radio Controller Board).
Table 608: RC Hardware Translation Audit (#1317) 1 of 3
Error
Code
Test
Result
Description / Recommendation
RC Hardware Translation Audit (#1317)
2000 ABORT No response to the test from the RC circuit pack.
1. Retry the command at 1-minute intervals up to 5 times.
2. If no response, busy, reset, and release the RC board to
re-initialize it. Retry the command.
3. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1 FAIL The RC has incorrect radio frequencies.
1. Enter display radio-controller loc to check the
administration. If administered translations are wrong, use
change carrier-frequencies and/or change system
parameters wireless to modify as needed.
2. Re-initialize the RC board using the busy, reset, and release
commands.
2 FAIL RC has incorrect cluster ID
1. Enter display radio-controller loc to check the
administration. If administered translations are wrong, use
change carrier-frequencies and/or change system
parameters wireless to modify as needed.
2. Re-initialize the RC board using the busy, reset, and release
commands.
1 of 3
Communication Manager Release 5.0 Issue 4 January 2008 1987