Server Alarms - Avaya Support

Table 643: Ring Generator Interchange Test (#1539) 2 of 2
Error
Code
Test
Result
Ring Generator Status Test (#1540)
Ring Generator Status Test (#1540)
2500 ABORT An internal operation failed.
1. Repeat the command at one-minute intervals 1 to 3 times.
2. If the test continues to abort escalate the problem.
1 FAIL There is no ringing voltage on the backplane when interchanging the ring
generator to this power supply.
1. Run test board.
64 FAIL Unable to interchange the ringers. The power supply being tested has its
ringer turned off.
65 FAIL Unable to interchange the ringers. The power supply not being tested has
its ringer turned off.
PASS The ring generation on redundant power supplies successfully
interchanged.
NO
BOARD
Description and recommendation
Power supply is administered but not detected.
1. Verify that the power supply is plugged in.
2. If the power supply was already plugged in, replace the power supply.
The ring generator status test verifies that the power supply ring voltage detector detects the
presence of ringing voltage. The operational status information from the ring generator does not
indicate that the generator is:
● shut down because it has an internal fault or shorted lead
● active but its output is operating under overload
This test does not fail if the ring selector switch on the 655A power supply is disabled.
This test runs on This test runs on PS-RGEN (Power Supply Ring Generator).
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 2053