Server Alarms - Avaya Support

Expansion Interface Control Channel Test (#316)
If the circuit pack is a standby ATM-EI or EI (amber LED off), this test queries the circuit pack for
its type and vintage information. This test runs on ATM-EI (Expansion Interface Circuit Pack)
and EXP-INTF (Expansion Interface Circuit Pack).
Table 488: Expansion Interface Control Channel Test (#316) 1 of 2
Error
Code
Test
Result
Description / Recommendation
1030 ABORT The test is not being executed on the active PE in a duplex system.
1335 ABORT The PKTINT is on the standby SPE
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL The ATM circuit pack responded incorrectly, or a PN’s active ATM-EI or
EI circuit pack could not communicate with the PN’s circuit packs.
1. If the PN’s active ATM-EI or EI circuit pack is failing and duplicated
PNC is enabled:
a. Enter reset PNC interchange to switch to the standby PNC.
b. Repeat the short test sequence.
c. If test continues to fail, enter reset board location to reset
the circuit pack.
2. If the PN’s unduplicated ATM-EI or EI circuit pack is failing:
a. Enter display errors and display alarms, and follow the
associated repair procedures for TDM-CLK (TDM Bus Clock),
TONE-BD (Tone-Clock Circuit Pack), or SYNC (Port Network
Synchronization) alarms/errors.
b. Repeat the short test sequence.
c. If test continues to fail, replace the circuit pack or transceiver.
PASS The circuit pack responded correctly to the test. Communication from
software to the ATM-EI or EI circuit pack is functioning.
1. Refer to other ATM-EI or EI circuit pack tests if the link is not
functioning correctly.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1711