Server Alarms - Avaya Support

INADS (INADS Link)
● If the initial test result was Command successfully completed, any logged error
codes would range from 1–9.
● If the initial test result was Command failed, any logged error codes would be 10 or 11.
An error is logged at the alarm receiver even if the call to the alarm receiver finally succeeds.
The alarm receiver’s software:
1. Recognizes this special “test inads” alarm type
2. Automatically opens and closes a trouble ticket
Within the trouble ticket, a field containing the description TESTING INADS LINK indicates
that the ticket was initiated by test inads-link.
After entering the command, up to 9 minutes can elapse before the switch places the call and
the alarm receiver responds. To determine whether the call was successful, the Error Log
should be examined by using the inads category 10 minutes after successfully entering the
command. Table 235: INADS Link Test Error Log Entries explains the error codes.
Error log entries and recommended actions
Table 235: INADS Link Test Error Log Entries 1 of 3
Error
Code
Test
Result
Description / Recommendation
1 0 A test call was successfully placed to the alarm receiver. No trouble found.
2 0 Informative error indicating that alarm origination was disabled at the time of
the test. The test runs even though alarm origination is disabled.
1. If desired, enable Alarm Origination via the Maintenance-Related System
Parameters screen.
2. Repeat the test.
3 0 The alarm receiver’s connection is currently in use.
1. Wait 10 minutes, and retry the command.
1 of 3
Communication Manager Release 5.0 Issue 4 January 2008 879