Server Alarms - Avaya Support

Table 608: RC Hardware Translation Audit (#1317) 3 of 3
Error
Code
Test
Result
ANY NO
BOARD
Description / Recommendation
RC NPE Allocation Test (#1336)
RC NPE Allocation Test (#1336)
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be changed
only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the RC
is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
PASS The RC is functioning normally.
This tests runs an RC NPE Allocation Test on a given RC. This test is run on RC-BD (Radio
Controller Board).
Table 609: RC NPE Allocation Test (#1336) 1 of 2
Error
Code
Test
Result
Description / Recommendation
2000 ABORT No response to the test from the RC circuit pack. The circuit pack may
be busied out.
1. Enter release board loc. Retry the command at 1-minute
intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
3 of 3
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1989