Server Alarms - Avaya Support

Table 476: Call State Audit Test (#257) 2 of 2
Error
Code
Test
Result
ISDN Test Call Test (#258)
This test performs a far-end looparound test over an ISDN trunk if:
● The trunk is in-service, maint-NE, or out-of-service/NE.
● No calls are active on the trunk.
Description / Recommendation
ISDN Test Call Test (#258)
1116 ABORT The trunk is in an out-of-service ISDN service state. A call cannot be
made if the trunk is in this state. No action is necessary.
ATM-BCH, ISDN-TRK, TBRI-TRK:
1. Check the trunk service state with status trunk grp#/mem#.
PE-BCHL:
1. Enter status pri-endpoint extension to investigate the ISDN
state of the port.
1700 ABORT Rollabout video abort. The PRI terminal adapter associated with this PRI
endpoint extension is detached from the circuit pack. This is a normal
abort when the rollabout video feature is enabled.
1. Reconnect the disconnected PRI terminal adapter or disable the
rollabout video feature on this circuit pack. To do the latter, enter
change ds1 location and set the Alarm when PRI Endpoint
Detached? field to y.
2100 ABORT Could not allocate needed resources
1. Retry the command up to 5 times at 1-minute intervals.
FAIL Internal system error
1. Retry the command up to 5 times at 1-minute intervals.
PASS A call-state auditing message was successfully sent to the far-end
terminal adapter to verify the state of the call active on this port. If a
call-state mismatch is found, the call is torn down within two minutes. If no
call was active, no message was sent.
● The system uses country protocol 1 (including US), or the far end has looparound
capability.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1689