Server Alarms - Avaya Support

Hybrid Line Local Digital Looparound Test (#58)
Hybrid Line Local Digital Looparound Test (#58)
This test checks the control channel between the server and the port’s digital circuitry. The
server sends data to the on-board microprocessor and compares the data echoed back. This
test is run on HYB-LINE (Hybrid Line).
Table 403: Hybrid Line Local Digital Looparound Test (#58) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Enter display port location to determine the station extension
number of the port.
2. Enter status station to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display port location to determine the station extension
number of the port.
2. Enter status station to determine the service state of the port. If
the port is in use, wait until it is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
1 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1525