Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 631: Short IP 2-Way Transmission Test (#1505) 2 of 3
Error
Code
2000
2012
2100
2500
ABORT Response to the test was not received in the allowed time.
System call failed. Internal system error.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT The IP Media Processor has not been administered on the
change ip-interface form.
1. Administer the IP Media Processor on the change
ip-interface form and rerun the test.
2806 ABORT The system could not find any in-service IP Media Processors to use as
a destination for this test.
2807 ABORT The specified IP Media Processor has been disabled on the
change ip-interfaces form.
1. Enable the IP Media Processor on the change ip-interfaces
form.
10XX
XX = PN #
Test
Result
Description / Recommendation
FAIL The test tone was not successfully sent from the IP Media Processor
specified in the test command and not successfully received by an IP
Media Processor in the PN specified in the error code XX.
The source to destination direction failed. The destination to source
direction was not tested.
1. Resolve all other board alarms for the specified source IP Media
Processor.
2. Resolve all other board alarms for the IP Media Processors in the
destination PN.
3. Use ping and traceroute to localize the problem to the
customer’s LAN/WAN IP network.
2022 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 3