Server Alarms - Avaya Support

ATM-TRK (Circuit Emulation Service Circuit Pack)
k. Error Type 1538: The ATM-TRK circuit pack is hyperactive (sending an abnormal number
of control messages to the processor). Use the following command sequence for this
ATM-TRK circuit pack:
1.busyout board location
2.reset board location
3.test board location long
4.release board location
5. If this error persists, replace the circuit pack.
l. Error Type 1794: LANHO transmit FIFO overflow. The circuit pack’s transmit buffers have
overflowed.
1. Run test board location r 5. If Test #598 fails, replace the circuit pack.
m. Error Type 2049: ACL Link Failure (link is down). The ATM Control Link (ACL) has failed,
communication has been interrupted between the server and the ATM-TRK circuit packs on
the system, and signaling-group parameters are not communicated across the packet bus.
1. Check the PKT-BUS (Packet Bus) and SYS-LINK (System Links) MOs, and follow the
repair procedures indicated.
2. Run test board location against the ATM-TRK circuit pack. If Test #598 fails, follow
the repair procedures for Packet Interface Test (#598)
n. Error Type 2306: too many parity errors in data received from the LAN/packet bus.
1. Run test board location
If Then
Test 598 fails. Follow the repair procedures for Packet Interface Test
(#598).
Test 598 passes See PKT-BUS (Packet Bus) and perform the
specified repair.
There are no errors against
the packet bus MO
This can be a transient condition. Do nothing now, but
escalate if the error occurs repeatedly.
o. Error Type 2561: Packet Interface Looparound test (#598) failure. The ATM-TRK circuit
pack has failed, the packet bus has a minor alarm active, or the packet bus is out of service.
Communication Manager Release 5.0 Issue 4 January 2008 569