Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 632: Long IP 2-Way Transmission Test (#1506) 3 of 3
Error
Code
Test
Result
0 NO
BOARD
Description / Recommendation
PASS The customer network is functioning properly. The test tone was
transmitted and received successfully between the IP Media Processor
specified in the test command and every other IP Media Processor in
the set of connected IP network regions.
See NO BOARD for repair procedures.
Verify NIC Options Test (#1511)
The Verify NIC Options Test checks if the circuit pack’s network interface parameters
(auto-negotiate, speed, and duplex) match with its administration.
The test passes if the NIC parameters match circuit pack administration. The test fails if the NIC
parameters do not match.
This test runs on IPMEDPRO (IP Media Processor) and ETH-PT (Control LAN Ethernet).
Table 633: Verify NIC Options Test (#1511) 1 of 4
Error
Code
Test
Result
Description / Recommendation
2026 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
3 of 3
1014 ABORT Board is not inserted.
1. Enter list configuration board to ensure that the circuit pack
is inserted in the carrier.
2. If the board is not inserted, make sure the circuit pack is inserted in the
carrier and fully seated.
1022 ABORT Invalid board. The board is not capable of changing its Ethernet options.
1115 ABORT Unable to allocate system resources to run this test.
1. Retry the test at one minute intervals up to a maximum of 3 times.
1 of 4