Server Alarms - Avaya Support

Table 573: Resource Looparound Test (#1111) 2 of 2
Error
Code
Resource Looparound Test (#1111)
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The resource has been seized by a user for a valid call.
1. Enter status conference to verify that there is an active
conference call.
2. If there are no conference calls, retry the command at 1-minute
intervals up to 5 times.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the test at 1-minute intervals up to 5 times. If this result occurs
repeatedly, reset the circuit pack if the other ports are idle and rerun
the test.
2. If this result occurs again, replace the circuit pack.
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
0
1
2
Test
Result
Description / Recommendation
FAIL This resource cannot guarantee data integrity and is out-of-service. The
following Error Codes indicate failure of a particular media loop:
0 = video
1 = audio
2 = low-speed data
1. Replace the circuit pack.
PASS The resource is functioning normally.
2 of 2
Communication Manager Release 5.0 Issue 4 January 2008 1919