Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Figure 133: Internal Looparound Test
A signaling message is sent through the digital port circuit pack to the data module, requesting it
to enter looparound mode. A test pattern is then sent from the TN771D Maintenance/Test circuit
pack, over the path illustrated above, and back to the TN771D where it is checked for
consistency.
The test aborts if any of the following local resources are not available:
● A digital port on the TN771D. There are two such digital ports, but only one may be used
at a time.
● Two TDM time slots
● An idle digital port connected to the data module
Table 454: Data Module Internal Looparound Test (#175) 1 of 4
Error
Code
Switch
TN771
Maintenance/
Test circuit
pack
Test
Result
TDM
bus
Digital
line
circuit
pack
Description / Recommendation
Data module
(MPDM, DA, MTDM)
1000 ABORT System resources required to run this test are not available. The port may
be in use on a valid call.
1. Enter status data-module to determine when the port is
available for testing.
2. Retry the command at 1-minute intervals up to 5 times.
1636 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
Data
equipment
pdmodul2 LJK 072501
1 of 4