09.12.2012 Views

Server Alarms - Avaya Support

Server Alarms - Avaya Support

Server Alarms - Avaya Support

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Table 459: 140AY Looparound Test (#210) 2 of 3<br />

Error<br />

Code<br />

Test<br />

Result<br />

Description/ Recommendation<br />

140AY Looparound Test (#210)<br />

1003 ABORT The system could not allocate a tone receiver for the test. The system may<br />

be oversized for the number of Tone Detectors present, or some Tone<br />

Detectors may be out of service.<br />

1. Enter list measurements tone-receiver to see information<br />

regarding the system’s tone receivers.<br />

2. Resolve any TTR-LEV (TTR Level) errors.<br />

3. Resolve any TONE-PT (Tone Generator) errors.<br />

4. Retry the command at 1-minute intervals up to 5 times.<br />

1007 ABORT The Announcement circuit pack thinks that Port 1 or Port 9 is busy.<br />

1. Retry the command at 1-minute intervals a maximum of 5 times.<br />

2. If the test continues to abort, follow the ANN-PT (Announcement Port)<br />

maintenance procedures for Ports 1 and 9.<br />

1024 ABORT Announcement circuit pack blocked the test because an announcement<br />

download is in progress. If an announcement download is in progress,<br />

status data-module should<br />

show that the announcement data port is connected to a NETCON data<br />

channel, and the "card-in-use" LED for the memory card should be on (to<br />

determine the extension of the announcement data module, use list<br />

data-module). See Note (a) at end of the table for Test #205 for more<br />

information.<br />

1. Wait until the download is finished, which can take up to 45 minutes.<br />

Run the test again.<br />

2. If the test continues to abort and there is no download in progress,<br />

escalate the problem.<br />

2000 ABORT Response to the test request was not received within the time allowed.<br />

1. Enter display errors. If Error Type 1538 is present in the Error<br />

Log for this board, reset the circuit pack.<br />

2. Retry the test at 1-minute intervals up to 5 times.<br />

2007 ABORT The Announcement circuit pack thinks that Port 1 or Port 9 is busy.<br />

1. Retry the command at 1-minute intervals a maximum of 5 times.<br />

2. If the test continues to abort, follow the Announcement Port<br />

maintenance procedures for Ports 1 and 9.<br />

2 of 3<br />

Communication Manager Release 5.0 Issue 4 January 2008 1649

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!