Server Alarms - Avaya Support

Table 528: Tie Trunk Seizure Test (#747) 2 of 3
Error
Code
Test
Result
Description / Recommendation
Tie Trunk Dial Test (#747)
1000 ABORT System resources required to run this test are not available. The
trunk may be busy with a valid call.
1. Enter display trunk-group xx to determine the trunk
group/member number of the port.
2. Enter status trunk to determine the service state of the port.
If the service state indicates that the port is in use, wait until the
port is idle before retesting.
3. If the port status is active but the port is idle (no calls), check the
Error Log for Error Type 1025. See the Error Log table for
TIE-TRK (Analog Tie Trunk) for the description of this error and
required actions. The port may be locked up. The far-end may
not be releasing.
4. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display trunk-group xx to determine the trunk
group/member number of the port.
2. Enter status trunk to determine the service state of the port.
If the service state indicates that the port is in use, wait until the
port is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT This test is not valid for this trunk translation. Must be a wink-start or
delay dial trunk and must be outgoing or 2-way for this test to run.
For the TN2140, the trunk must also be continuous-seize-ack or
discontinuous-seize-ack.
1. Check trunk translation. If it is not a wink-start or delay dial
trunk, this abort message should be ignored.
1018 ABORT Test disabled via administration.
1. Verify that the Maintenance Tests field on the Trunk Group
screen is n. To enable the test, enter change trunk-group x
where x is the number of the trunk group to be tested, and enter
y in the Maintenance Tests field.
2 of 3
Communication Manager Release 5.0 Issue 4 January 2008 1795