Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 607: RC NPE Port Loop Test (#1316) 2 of 2
Error
Code
Test
Result
1-24 ABORT The Error Code identifies the NPE for which the test aborted. The NPE
is probably being allocated for a call.
1. Enter status radio-controller loc to verify there are no
calls on the RC circuit pack.
2. If not, retry the command at one-minute intervals up to 5 times.
3. If the test continues to abort, escalate the problem.
1-24 FAIL The Error Code identifies the NPE for which the RC NPE Port
Crosstalk test failed.
1. Enter test board loc long repeat 24
2. If any of the tests fail, replace the RC circuit pack.
ANY NO
BOARD
Description / Recommendation
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be changed
only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the RC
is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
PASS All of the NPEs are functioning normally.
RC Hardware Translation Audit (#1317)
This tests validates that the operating parameters which are translated for an RC circuit pack
match those that have been previously downloaded to the circuit pack.
If this audit fails, an error will be logged and a WARNING alarm generated. However, no attempt
will be made to correct the mismatched data by re-downloading to the RC. Instead, the RC
circuit pack needs to be reset to have the operating parameters re-downloaded to the circuit
pack. The RC circuit pack cannot accept operating parameter updates and still remain
in-service.
1986 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 2