Server Alarms - Avaya Support

CLAN-BD (Control LAN Circuit Pack)
c. Error Type 217: applies to 10 circuit packs:
1. Remove the circuit pack(s) against which the error is logged.
d. Error Type 257: Transient communication problems between the switch and circuit pack.
This error is not service affecting and can be ignored unless repeated failure of the Control
Channel Looparound test (#52) indicates a hardware failure of the circuit pack. If this is the
case, replace the circuit pack.
e. Error Type 513: Circuit pack detected a hardware failure. Reset the circuit pack with
reset board location.
Aux Data 4352: External RAM error
Aux Data 4353: Internal RAM error
Aux Data 4355: ROM Checksum error
Aux Data 4357: Instruction set error
f. Error Type 769: Program logic error. By itself this error may be ignored, but it may result in
other Error Types being reported.
g. Error Type 1290-1297: A critical hardware or firmware error has been detected on the
circuit pack.
If the switch detects: Then the switch:
1 error, Resets circuit pack.
3 errors in 15 minutes, Raises MINOR alarm.
1. Attempt to clear the alarm with reset board location command
2. If the alarm persists, replace circuit pack.
h. Error Type 1537: The circuit pack is hyperactive. The switch has taken it out of service.
1. Attempt to clear the alarm with the reset board location command
2. If the error happens again within 15 minutes, replace the circuit pack.
i. Error Type 1794: packet bus transmit buffers have overflowed.
1. Attempt to clear the alarm with the reset board location command.
2. If the error recurs within 15 minutes, replace the circuit pack.
j. Error Type 1796, Aux Data 42611: DLCI out of range. The switch activates congestion
controls on C-LAN when it detects buffers exceeding the threshold. The switch releases the
congestion controls when the C-LAN reports that its buffer level has returned to normal. A
minor alarm is raised if congestion persists for 14 minutes or if buffers are exhausted
because of congestion. The alarm is retired when the alarm condition ceases for 12
minutes.
1. Attempt to clear the alarm with reset board location.
2. If the alarm recurs within 15 minutes, replace the circuit pack.
Communication Manager Release 5.0 Issue 4 January 2008 643