Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 382: GPP NPE Crosstalk Test (#9) 2 of 6
Error
Code
Test
Result
Description / Recommendation
1000 ABORT System resources required to run this test are not available or the port
may be busy with a valid call.
ADX8D-PT and ADX16D-P:
1. Enter display port location to determine the extension of the
port.
2. Enter status station location to determine the service state
of the port. If the port is in use, wait until it is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
DIG-LINE and E-DIG-ST:
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station extension or status attendant
location to determine the service state of the port. If the port is in
use, wait until it is idle before testing. Attendants are always in use
(off-hook) if the handset is plugged in and the port is not busied out.
3. Retry the command at 1-minute intervals up to 5 times.
M/T-ANL:
1. The port may be in use on a valid ATMS trunk call. Retry the
command at 1-minute intervals up to 3 times.
M/T-DIG:
1. Enter list isdnpri-testcall to determine if the port is in use
(listed in the M/T Port column). If so, wait for the test call to finish as
indicated in the Start Time and Duration fields, or abort the test call
with clear isdnpri-testcall grp#/mem#, where grp#/
mem# is determined from the B-Channel field of list
isdnpri-testcall.
2. Retry the command at 1-minute intervals up to 5 times.
PDMODULE and TDMODULE:
1. Enter display port location to determine the extension of the
port.
2. Enter status data-module extension to determine the
service state of the port. If the port is in use, wait until it is idle before
retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1458 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 6