Server Alarms - Avaya Support

Table 540: Failure Audit Test (#777) 2 of 3
Error
Code
Test
Result
Description / Recommendation
Failure Audit (#777)
2306 ABORT An SNI circuit pack on the fiber link is not responding to test requests
sent by software.
1. Run test led switch-node for the switch node(s) where the
SNI(s) reside to verify whether the LEDs on the board(s) light. Follow
the steps below for the SNI(s) from step 1 that had no LEDs light.
2. If the LEDs on the other boards in the carrier light, but the LEDs on
this board do not light, run test 760 using test board location
long for the active SNC in this carrier. Wait 5 minutes, then try step
1 one more time. If the LEDs on this board still do not light, replace
this board. Replacing an SNI may be service interrupting. Refer to
the documentation for SNI-BD (SNI Circuit Pack) for the procedure to
replace an SNI.
a. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this
carrier to the server. Enter list fiber-link to determine the
fiber connections to this carrier. Check the LEDs on every SNI and
EI, and fix any fiber problems. Enter display errors and
resolve any EXP-INTF (Expansion Interface Circuit Pack) error
entries associated with the Port Network. Also, Follow the repair
procedures if there are errors for any of the following:
● SYNC (Port Network Synchronization)
● SNI-BD (SNI Circuit Pack)
● SNC-BD (Switch Node Clock Circuit Pack)
● FIBER-LK (Fiber Link)
● SNI-PEER (SNI Peer Link)
2 of 3
Communication Manager Release 5.0 Issue 4 January 2008 1841