Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 408: Tie Trunk Seizure Test (#73) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1000 ABORT System resources required to run this test are not available. The
trunk may be busy with a valid call.
1. Enter display trunk-group xx to determine the trunk
group/member number of the port.
2. Enter status trunk to determine the service state of the port.
If the service state indicates that the port is in use, wait until the
port is idle before retesting.
3. If the port status is active but the port is idle (no calls), then
check the Error Log for Error Type 1025. See the Error Log table
for a description of Error Type 1025 for this maintenance object.
The port may be locked up. The far-end may not be releasing.
4. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
1004 ABORT The port was seized by a valid call during the test.
1. Enter display trunk-group xx to determine the trunk
group/member number of the port.
2. Enter status trunk to determine the service state of the port.
If the service state indicates that the port is in use, wait until the
port is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT This test is not valid for this trunk translation. The trunk must be a
wink-start or delay dial trunk and must be outgoing or 2-way for this
test to run. For the TN2140, the trunk must also be
continuous-seize-ack or discontinuous-seize-ack.
1. Check trunk translation. If it is not a wink-start or delay dial
trunk, this abort message should be ignored.
1018 ABORT Test is disabled by administration.
1. Verify that the Maintenance Tests field on the Trunk Group
screen is n. To enable the test, enter change trunk-group x
where x is the number of the trunk group to be tested, and enter
y in the Maintenance Tests field.
1534 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
2 of 3