Server Alarms - Avaya Support

Table 519: BRI Layer 3 Query Test (#629) 3 of 4
Error
Code
Test
Result
Description / Recommendation
BRI Layer 3 Query Test (#629)
1187 ABORT The circuit pack, port or station may have been busied out by a
technician.
1. Look in the Error Log for Error Type 18 (busied out) for BRI-BD,
BRI-PORT, or BRI-SET.
a. If this Error Type is present for BRI-SET only, release the station
with release station.
b. If this Error Type is present for BRI-PORT and BRI-SET, release
the port with release port location and run the test again.
c. If the error is present for BRI-BD, BRI-PORT, and BRI-SET,
release the circuit pack with release board location and
run the test again.
d. If the error is present for both BRI-BD and BRI-PORT, release the
circuit pack with release board location and run the test
again.
Note: When
Note:
you release the circuit pack, you release every port
associated with it. If certain ports still need to be busied
out, use busyout port location to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
2068 ABORT The endpoint has rejected the sent application message. This indicates
that the endpoint does not support the ISDN-BRI Management and
Maintenance Procedure for Endpoint Service messages.
1. Enter change station extension and change the
MIMs Supported (?) field to n.
3 of 4
Communication Manager Release 5.0 Issue 4 January 2008 1775