Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
This test runs on DS1C-BD (DS1 Converter Circuit Pack) and DS1-FAC (DS1 Facility).
Table 560: Failure Audit Test (#949)
Error
Code
2000
2100
2300
2301
Test
Result
Description / Recommendation
ABORT Test timed out while waiting for a response from the circuit pack.
Could not allocate the necessary system resources to run this test.
The downlink message necessary to run this test could not be sent.
The timer could not be set for the downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Enter add fiber-link to administer the DS1 converter fiber link.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
0 NO
BOARD
FAIL The DS1 converter circuit pack reported failures or retransmitted a
cleared failure message.
1. Enter display errors and follow the repair procedures for any
DS1C-BD (DS1 Converter Circuit Pack) and DS1-FAC (DS1
Facility) errors.
PASS The DS1 converter circuit pack has no failures.
PN Cold Restart Test (#955)
See NO BOARD for repair procedures.
PN Cold Restart, or PN Reset Level 2, is used as an error recovery mechanism for a PN that
has been taken out of service. Once a PN has gone out of service, a PN Cold Restart is
required to bring it back into service.
When a PN is taken out of service, all originating and terminating calls on the affected PN are
dropped and new phone calls cannot be made. During the restart, all hardware on the affected
PN will be re-initialized. The restart takes no longer than 2 minutes.
When the link has been down for 60 seconds, the PN is taken out of service. When the link
comes up, a PN cold restart will occur automatically. See PN Warm Restart Test (#956).
1892 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers