Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Removing Fiber Connectivity to an PN
This procedure covers removing the connectivity to an PN or between SNs. Removing an PN
and its associated carrier and circuit packs can be handled on a board-type basis.
If this system is duplicated, start with step 1; otherwise, start with step 6.
Note: The
WARNING: Do
WARNING: In
Note:
following procedure is generic in its scope. Check the customer’s switch
configuration for EI/SNI structures.
! WARNING:
not power down a Switch Node carrier to replace a circuit pack.
! WARNING:
duplicated PNC configurations, one DS1-CONV complex in the fiber-link
serves as the active and the second DS1-CONV complex serves as the standby.
Each DS1 Converter complex consists of two TN574 or TN1654 circuit packs.
Table 193: Removing Fiber Connectivity from a PN 1 of 2
Step Command/Step Description
1. status pnc Verify that the A-side is active.
1. If the B-PNC is active, enter
reset pnc-interchange
2. Verify that the A-side is active
(status pnc).
3. busyout pnc standby Busyout the duplicated switch side.
4. change system-parameters
duplication
Disable PNC duplication by setting the
Enable Operation of PNC
Duplication field to n.
5. list fiber-link List administered fiber connections by
number. Record the endpoints (EIs, SNIs,
and DS1Cs), and fiber link numbers that you
are removing.
6. busyout fiber-link n Busyout the fiber link of interest. The fiber link
number (step 4) is n for this command.
7. remove fiber- link n Remove the link administration for this link.
760 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
1 of 2