Server Alarms - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 498: Expansion Interface Packet Interface Test (#589) 5 of 5
Error
Code
Test
Result
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
ANY FAIL The transmitted data packet was not received correctly by the Packet
Interface circuit pack. The failure may be in the EI under test, the DS1
converter circuit packs, or the intervening Center Stage components.
1. Test the Packet Interface circuit with test packet-interface CS
where “C” is the IPSI’s carrier in a high- or critical-reliability system,
and “S” is the slot number where the IPSI’s Packet Interface resides.
If the Packet Interface circuit fails any tests, see PKT-INT (Packet
Interface).
2. If the EI under test resides in a high-reliability system’s PN,
(2 PN-to-CSS fibers in an unduplicated PNC), run the short test
sequence on both of the PN’s EI boards, and follow procedures for
Test #589.
3. Enter display errors and resolve any PKT-BUS errors.
4. Perform the Fiber link fault isolation in Chapter 4: General
troubleshooting in Maintenance Procedures (03-300432).
PASS Although this test has passed, there may be related problems on other
EIs used in connectivity to and from this EI. Software may have
conducted tests on these other components and determined that this
board was functioning properly and any problems were probably due to a
problem with some other connectivity component. Check the error and
alarm logs for problems with other EI circuit packs and resolve these
errors.
1. Refer to other EI board tests if the link is not functioning correctly.
0 NO
BOARD
Description / Recommendation
See NO BOARD for repair procedures.
1734 Maintenance Alarms for Avaya Communication Manager, Media Gateways and Servers
5 of 5